wear test

The Wear Simulating Test of Cylinder and Piston Ring

内燃机汽缸套活塞环模拟磨损试验

互联网摘选

In order to customise the test to your requirements, choose from a wide variety of abrading wheels and abraser accessories to simulate real-life wear conditions.

为了自定义的测试您的要求，选择从磨石配件种类繁多的研磨轮，以模拟真实的磨损情况。

互联网摘选

Simulating wear test for cylinder and piston ring friction pairs

缸套活塞环摩擦副的模拟磨损试验研究

互联网摘选

Study of surface strengthening technology and wear test of diesel engine cylinder liner

柴油机气缸套表面强化工艺及磨损试验的研究

互联网摘选

When the coatings were in lubricated wear test, the coefficient of friction rapid reduce to 0.12.

陶瓷层涂抹润滑油后，与钢球对磨的摩擦系数降低至0.12。

互联网摘选

Research on Ball Particles Formation Mechanism in Contact Fatigue Wear Test

接触疲劳磨损试验中球形磨损微粒形成机理研究

互联网摘选

A to-and-fro wear test apparatus was devised to investigate the tribological properties of fresh swine thighbones under various lubrication conditions.

自行设计了一种往复运动的摩擦磨损试验机，在该试验机上对新鲜猪股骨在不同润滑方式下的摩擦学特性进行了研究。

互联网摘选

The wear characteristics and current-carrying characteristics between immersed copper carbon pantograph slide and copper-tin alloy wire are studied, and the mechanism is analyzed by using the sliding electrical contact wear test machine self developed.

利用自行研制的滑动电接触磨耗实验机，研究了浸铜碳滑板和铜锡合金导线之间的磨耗特性和载流特性，并进行机理分析。

互联网摘选

The sliding wear tests have been carried out with MHK-500 ring-on-block sliding wear test machine under paraffin oil lubrication condition.

在石腊基础油润滑条件下，应用MHK500环块滑动磨损试验机进行滑动磨损试验。

互联网摘选

Rapid Wear Test of Steel Matrix PM Composite Reinforced With SiC Particles

SiC颗粒增强的钢基复合材料的快速磨损试验研究

互联网摘选

The Evaluation of Glycol Water Based Hydraulic Fluids in Continuous Four Ball Wear Test

采用连续四球机试验评价水-乙二醇难燃液的抗磨性

互联网摘选

Analysis of Wear Test for Spherical Joint Bearing Wih Self Lubrication

自润滑关节轴承的磨损试验分析

互联网摘选

The wear mass loss of the Mo2Ni3Si/ NiSi silicide composite coatings increases very slowly with increasing wear test load under room-temperature sliding wear test conditions.

在常温滑动磨损条件下，Mo2Ni3Si/NiSi金属硅化物复合材料涂层的质量损失随着载荷的增加缓慢增加；

互联网摘选

The results of wear test, hardness and crystallinity measurement show that the filling materials will lower the crystallinity.

结晶度测试、摩擦学性能测试及硬度测试结果表明：填充材料不同程度降低了复合材料的结晶度，而结晶度的降低表征了材料耐磨性能的提高和减摩性能的降低。

互联网摘选

The friction and wear tests of the self lubricating bearing made of carbon fiber reinforced copper matrix composite materials are arranged by uniform design that can greatly reduce the test duration.

根据均匀设计原理，对碳纤维增强铜基复合材料的磨损试验参数予以科学排列，不仅减少了试验次数，而且提高了试验数据统计结果的可靠性。

互联网摘选

Wear test machinery of complex motion and its kinematic analysis

复杂运动磨损试验机构及运动学分析

互联网摘选

A New Type of Corrosive Wear Test Device and Its Performance Study

一种新型腐蚀磨损实验装置及其性能研究

互联网摘选

The relations among the normal objective test test and the subjective wear test are discussed.

探讨了服装舒适性研究的三类方法(常规容观试验、假人试验、主观试验)之间的关系.

网络文摘精选

Being aimed at the stressing and damaging reasons of bridge surface layers, this paper mainly deals with the bending resistance test and wear test of steel fiber concrete materials, analyzes the bending performance of steel fiber concrete, and expounds the wear-resisting mechanism.

针对桥面铺装层的受力状况和破坏原因，重点对钢纤维砼材料进行了抗弯强度试验和耐磨损试验，并进行了钢纤维砼弯曲性能分析，闸述了钢纤维砼的耐磨机理；

互联网摘选

The wear mechanism under all test situations is abrasion wear and plough wear.

所有润滑条件下试样均以磨粒磨损或犁削磨损为主.

互联网摘选

The effect of different Mo additions on the microstructure and wear resistance of the nickel-based alloy coating produced by plasma cladding was investigated using optical microscope, scanning electron microscope ( SEM), X-ray diffraction ( XRD), transmission electron microscope ( TEM), and sliding wear test.

应用光学显微镜、扫描电镜（SEM）、X射线衍射（XRD）、透射电镜（TEM）以及滑动磨损实验，研究不同Mo加入量对等离子熔覆镍基合金涂层组织结构和性能的影响。

互联网摘选

Abrasion wear test of Fe-20% Cr ahoy with carbon content ranging from 0.82% to 2.94% was conducted at 800 ℃ in a self-made high temperature wear tester. The worn surfaces and subsurfaces were observed by SEM.

本文用自制的高温磨损试验机对碳含量0.82～2.94%的Fe-20%Cr合金进行了800℃下的高温磨损试验，并用扫描电镜观察了磨损面和磨损面亚表面的情况。

互联网摘选

The result shows that in the ring-block sliding wear test, with time prolonging, the friction coefficient of all samples becomes more and more stable, and the mass wear loss increases.

结果表明：在环-块滑动摩擦实验中，随时间延长，试样摩擦系数均趋向平稳，质量磨损量均增长。

互联网摘选

The microstructure and micro-hardness of the coating were evaluated by SEM, XRD, EDS and micro-hardness instrument, the room temperature and high temperature wear properties were evaluated under dry sliding wear test conditions, and the wear mechanism was discussed.

利用SEM，XRD，EDS和显微硬度计等分析了涂层的显微组织和硬度，分别在室温干滑动磨损及高温滑动磨损条件下测试了涂层的耐磨性，并讨论了其磨损机理。

互联网摘选

The laser cladding coating with the moderate ( 2.0mm/ s) scan-rate exhibits the best wear-resistance under the full dry sliding wear test condition.

在中等扫描速度下（2.00mm/s）获得的涂层具有最好的滑动磨损耐磨性。

互联网摘选

Then the microstructure of the compound layer is observed through the microscope and the X rays diffractometer. In addition the pure sliding wear test has been done with the MPX-200 wear test machine.

通过金相显微镜和X射线衍射仪观察了化合物层的显微组织和微观结构及在MPX200型盘销式摩擦磨损试验机上进行纯滑动干磨损试验。

互联网摘选

The specimens for fretting wear test were cut from the as-weldweld zone metals for qualified weldment.

在焊接检验合格的焊态试件上从焊缝区、熔合区和焊接热影响区金属中分别截取并制备微动磨损试验用试样.

互联网摘选

The Abrasion Test of Cast Wear Resistant Materials in Nitric Acid

铸造耐磨材料在硝酸中的磨粒磨损试验研究

互联网摘选

The test indicates that contact fatigue life and wear resistance of surface quenched casting steels and Bainite quenched spherical cast iron are increased largely.

试验表明：经过表面淬火的铸钢和经过贝氏体淬火的球墨铸铁，其接触疲劳寿命和耐磨性大幅度提高。

互联网摘选

The study had been proceeded by means of wear test, hardness test, XRD phase testing, metallographic analysis and scanning electron microscopy ( SEM) analysis and other methods.

采用磨损性能测试、硬度测试、XRD物相检测、金相分析及扫描电镜（SEM）等方法进行研究分析。

互联网摘选